Quick Settings - Keysight N9913A User Manual

NA (Network Analyzer) Mode
NA Mode Settings
How to select a multi-trace configuration
— Press Trace 6
— Then
— Then choose from the following:
How to activate a trace in order to change a setting
— Use the
— Press Trace 6 then select
How to maximize the viewing of the active trace
— Press System 7
— Then
— Press any key to return to the standard display.

Quick Settings

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
How to view and change Quick Settings
— Press Meas Setup 4
90
Num of Traces
The default measurements depend on the options that are installed
arrows OR
that are shown can be activated.
Full Screen.
x1
1 trace standard configuration
x2
2 traces overlayed on a single graticule
x2H
2 traces on separate graticules
x3H
3 traces on separate graticules
x3
3 traces overlayed on a single graticule
x4H
4 traces on separate graticules
Trace 1, Trace 2, Trace
Keysight N9927-90001 User's Guide
3, or Trace 4, Only traces