Display - Keysight N9913A User Manual

Fieldfox analyzers

Hide thumbs Also See for N9913A:

Table of Contents

System Settings

Display

Startup Mode

The Startup Mode setting determines the mode that becomes active (visible)

when User Preset is set to OFF (Factory Preset) and the FieldFox is powered

How to setup Startup Mode

— Press System 7

— Then scroll to Global Settings > Startup Mode and press Edit.

— Then repeatedly press the

Choose the Display values (Display Colors, Trace Width, Brightness, Title

Enabled, Title). See

How to select Display values:

— Press System 7

— Then use arrow softkeys or the knob to select Display

Keysight N9927-90001 User's Guide

a constant, uninterrupted RF output from the RF OUT port. This

behavior also provides the highest trace stability sweep-to-sweep

which may only be evident while using either single sweep or

Run/Hold. With Battery Saver OFF, the use of a full battery charge is

reduced by approximately 45 minutes.

"User Preset" on page

is the factory default mode for your FieldFox model.

— Built-in Power Meter Mode is NOT allowed as a Startup Mode.

"Display (Settings)" on page

for each of the following:

— Display Colors

— Indoor (default)

— Night Vision

— Outdoor Sun

— Outdoor Dusk

Startup Mode

to scroll through the available

Table of Contents