Power On - Keysight N9913A User Manual

System Settings
System Configuration
— Then LAN.
— Use the
— Hostname Change the name that can be used to address the FieldFox if
— Obtain IP Choose from:
For all FieldFoxes with firmware ≤A.08.18 and ≤A.09.50 FW, when
using Static IP addresses:
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
— Static Gateway - Enter the Static Gateway – including periods - in the
— Static DNS - Enter the Static DNS – including periods - in the format
— Apply Settings Choose from:
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
— Press

Power ON

When the FieldFox is without a power source, this setting allows the FieldFox
to power ON as soon as a charged battery or the DC Adapter is inserted
without pressing the power button.
498
arrows to select one of the following, then press Edit.
your server supports this feature. The default hostname is generated
automatically.
— DHCP - IP Address is assigned dynamically. If your server supports
this feature, the IP Address for the FieldFox is assigned each time it is
started.
— Static - Set the IP Address manually. The Address remains until you
change it.
— Static IP Address - Enter the IP Address – including periods - in the
format nnn.nnn.nnn.nnn
— Either a valid Static Gateway is required or 0.0.0.0.
— Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)
format nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
— Power Up The above settings take effect when the FieldFox is
started.
— Now The above settings take effect immediately.
Done Edit when finished.
Keysight N9927-90001 User's Guide