Using The Antenna/Cable Editor - Keysight N9913A User Manual

SA (Spectrum Analyzer) Mode
SA Mode Settings

Using the Antenna/Cable Editor

The Antenna Editor and the Cable Editor menus are very similar. Both tables
include header information, and a Frequency/Value table.
In any correspondence or telephone conversation, refer to the product by
its model number and full serial number. With this information, the
Keysight representative can determine the warranty status of your unit.
Figure 9-2 FieldFox Antenna Editor
How to use the Antenna/Cable Editor
— Press
— Then
— Then use the
156
New then Yes to clear all data from the existing Antenna or Cable
table and reset header information to default settings.
Edit Antenna or
arrows to select a field.
— To edit header information, press
using the FieldFox labeler.
——Description: Enter a description for the antenna or cable
correction table. This is NOT the filename used to save the file.
——Antenna Unit (Rcvr-side Antennas only): Units in which the
measurement will be displayed. Select NONE (default setting)
to select from standard SA Units on the Scale menu. Learn how
in "Scale and Units" on page
——Choose from: dB μV/m - (dB micro Volts per meter), dB μA/m
- (dB micro Amps per meter), dBG (gauss), dBpT (tesla).
Edit Cable to open the Antenna / Cable Editor.
Edit
151.
Keysight N9927-90001 User's Guide
then modify the selected field