Independent Source/Tracking Generator - Keysight N9913A User Manual

SA (Spectrum Analyzer) Mode
SA Mode Settings
To select Listen Time:
— Press Meas Setup 4
— Then
— Enter a value using the numeric keypad,
Volume Control
To increase or decrease the Volume of the demodulated signal:
— Press Meas Setup 4
— Then
— Enter a value in percent between 0 and 100 (loudest) using the numeric
— Volume can also be changed and easily muted from the System menu.
Demod ON and OFF
To quickly stop the audio demodulation and perform only the normal SA
sweeps, select the following:
— Press Meas Setup 4
— Then

Independent Source/Tracking Generator

For best results, when using the independent source feature, InstAlign and
the battery saver features should be turned off. Refer to
Individual Alignments" on page 181
This feature may require an option. For a comprehensive list, view the FieldFox
Configuration Guide at:
http://literature.cdn.keysight.com/litweb/pdf/5990-9836EN.pdf
A tracking generator, a popular option with Spectrum Analyzers, is a source
which always tracks the SA receiver.
Like a traditional tracking generator, the Independent Source feature can set
the internal FieldFox source to track the SA receiver frequency range. It can
also set the internal source to a CW frequency that is independent of the SA
frequency.
Independent Source can be enabled ONLY when the FieldFox is in SA mode.
To view the internal source, you must connect a cable or device between the
RF Output connector and the RF Input connector.
Keysight N9927-90001 User's Guide
Listen Time
Then select a multiplier key. Learn about multiplier abbreviations.
Volume
keypad, arrows, or the rotary knob.
Learn more in "How to set the FieldFox Volume Control" on page
Demod ON OFF
arrows, or the rotary knob.
"How to Access
and "Preferences" on page
474.
477.
161