Dsr - Polycom HDX series Reference Manual

dsr

Sets or gets the configuration of the DSR serial interface control signal (data set
ready). This command is only applicable if you have a V.35 network interface
connected to your system.
Syntax
dsr <get|normal|inverted>
Parameter
get
normal
inverted
Feedback Examples
• dsr normal
• dsr inverted
Comments
The default setting for this signal is
Description
Returns the current setting.
Sets the signal to normal (high voltage is logic 1).
Sets the signal to inverted (low voltage is logic 1).
.
"normal"
System Commands
4 - 69