Cts - Polycom HDX series Reference Manual

cts

Sets or gets the CTS serial interface control signal (clear to send) configuration.
This command is only applicable if you have a V.35 network interface
connected to your system.
Syntax
cts <get|normal|inverted|ignore>
Parameter
get
normal
inverted
ignore
Feedback Examples
• cts normal
• cts inverted
Comments
The default setting for this signal is
Description
Returns the current setting.
Sets the signal to normal (high voltage is logic 1).
Sets the signal to inverted (low voltage is logic 1).
Ignores the signal.
.
"normal"
System Commands
4 - 49