Dcd - Polycom HDX series Reference Manual

dcd

Sets or gets the configure for the DCD serial interface control signal (data
carrier detect). This command is only applicable if you have a V.35 network
interface connected to your system.
Syntax
dcd <get|normal|inverted>
Parameter
get
normal
inverted
Feedback Examples
• dcd normal
• dcd inverted
Comments
The default setting for this signal is
Description
Returns the current setting.
Sets the signal to normal (high voltage is logic 1).
Sets the signal to inverted (low voltage is logic 1).
.
"normal"
System Commands
4 - 51