Configuring IAPs for Mobility Access Switch Integration
When an IAP is integrated with a Mobility Access Switch, the Link Layer Discovery Protocol (LLDP) is enabled.
Using this protocol, the IAPs instruct the switch to turn off the ports where rogue IAPs are connected, perform
actions such as increasing the PoE priority, and configure the VLANs on the ports to which the IAPs are
connected.
You can enable Mobility Access Switch integration either by using the Instant UI or the CLI.
In the Instant UI
To enable the Mobility Access Switch integration:
1. Navigate to System > General.
2. Select Enabled from the MAS integration drop-down list. The MAS integration status is displayed in the
Info area of the main window as shown in the following figure:
Figure 113 Mobility Access Switch Integration Status
In the CLI
To enable the Mobility Access Switch integration:
(Instant AP)(config)# mas-integration
(Instant AP)(config# end
(Instant AP)# commit apply
389
| Mobility Access Switch Integration
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide