Blacklisting Clients; Blacklisting Clients Manually; Adding A Client To The Blacklist - Aruba IAP-335 User Manual

10.Click OK to apply the changes.
The WISPr RADIUS attributes and configuration parameters are specific to the RADIUS server used by your ISP
for the WISPr authentication. Contact your ISP to determine these values. You can find a list of ISO and ITU
country and area codes at the ISO and ITU websites
A Boingo smart client uses a NAS identifier in the <CarrierID>_<VenueID> format for location identification. To
support Boingo clients, ensure that you configure the NAS identifier parameter in the RADIUS server profile for
the WISPr server.
In the CLI
(Instant AP)(config)# wlan wispr-profile
(Instant AP)(WISPr)# wispr-location-id-ac
(Instant AP)(WISPr)# wispr-location-id-cc
(Instant AP)(WISPr)# wispr-location-id-isocc
(Instant AP)(WISPr)# wispr-location-id-network
(Instant AP)(WISPr)# wispr-location-name-location
(Instant AP)(WISPr)# wispr-location-name-operator-name
(Instant AP)(WISPr)# end
(Instant AP)# commit apply

Blacklisting Clients

The client blacklisting denies connection to the blacklisted clients. When a client is blacklisted, it is not allowed
to associate with an IAP in the network. If a client is connected to the network when it is blacklisted, a
deauthentication message is sent to force client disconnection.
This section describes the following procedures:
Blacklisting Clients Manually on page 176
l
Blacklisting Users Dynamically on page 177
l

Blacklisting Clients Manually

Manual blacklisting adds the MAC address of a client to the blacklist. These clients are added into a permanent
blacklist. These blacklisted clients are not allowed to connect to the network unless they are removed from the
blacklist.

Adding a Client to the Blacklist

You can add a client to the blacklist manually using the Instant UI or the CLI.
In the Instant UI
1. Click the Security link located directly above the Search bar in the Instant main window.
2. Click the Blacklisting tab.
3. Under the Manual Blacklisting, click New.
4. Enter the MAC address of the client to be blacklisted in the MAC address to add text box.
For the blacklisting to take effect on the MAC address, you must enable blacklisting in the SSID profile. For
more information, see
5. Click OK. The Blacklisted Since tab displays the time at which the current blacklisting has started for the
client.
6. To delete a client from the manual blacklist, select the MAC Address of the client under the Manual
Blacklisting, and then click Delete.
176 | Authentication and User Management
Blacklisting on page 95.
(www.iso.org and http://www.itu.int).
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide