Client Match Configuration Parameters; Access Point Control - Aruba IAP-335 User Manual

Table 55: Client Match Configuration Parameters
Parameter
Client match
CM calculating
interval
CM neighbor
matching %
CM threshold
SLB mode
2. Click OK.
In the CLI
(Instant AP)(config)# arm
(Instant AP)(ARM)# client-match calc-interval <seconds>
(Instant AP)(ARM)# client-match calc-threshold <threshold>
(Instant AP)(ARM)# client-match nb-matching <percentage>
(Instant AP)(ARM)# client-match slb-mode 1
(Instant AP)(ARM)# end
(Instant AP)# commit apply

Access Point Control

You can configure access point control parameters through the Instant UI or the CLI.
In the Instant UI
1. For Access Point Control, specify the following parameters in the RF > ARM > Show advanced options
tab:
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Description
Select Enabled to enable the Client match feature on IAPs. When enabled,
client count will be balanced among all the channels in the same band. For
more information, see ARM Overview on page
feature is disabled.
NOTE: When client match is enabled, ensure that
Specify a value for calculating the interval of Client match. The value specified
for CM calculating interval determines the interval at which client match is
calculated. The interval is specified in seconds and the default value is 30
seconds. You can specify a value within the range of 10–600.
Specify a value for CM neighbor matching %. This number takes into account
the least similarity percentage to be considered as in the same virtual RF
neighborhood of client match. You can specify a percentage value within the
range of 20–100. The default value is 75%.
Specify a value for CM threshold. This number takes acceptance client count
difference among all the channels of client match into account. When the client
load on an IAP reaches or exceeds the threshold, client match is enabled on
that IAP.
You can specify a value within range of 1–255. The default value is 2.
Select a mode from the SLB mode drop-down list. The SLB mode determines
the balancing strategy for client match. The following options are available:
Channel
l
Radio
l
Channel + Radio
l
253. By default, the client match
Scanning is enabled.
Adaptive Radio Management | 257