Aruba IAP-335 User Manual page 64

Table 17: System Parameters
Parameter
Terminal access
Console access
Telnet server
LED display
Extended SSID
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Description
When Auto-Join feature is disabled, the inactive IAPs
are displayed in red.
When terminal access is enabled, you can access
the IAP CLI through SSH.
The terminal access is enabled by default
When enabled, you can access the IAP through the
console port.
To start a Telnet session with the IAP CLI, enable
access to the Telnet server.
LED display status of the IAP. To enable or disable
LED display for all IAPs in a cluster, select Enabled
or Disabled, respectively.
NOTE: The LEDs are always enabled during the IAP
reboot.
Extended SSID is enabled by default in the factory
default settings of IAPs. This disables mesh in the
factory default settings.
The RAP-108/109 access points support up to 6
l
SSIDs with Extended SSID disabled and up to 8
SSIDs with Extended SSID enabled.
All other IAPs support up to 14 SSIDs when
l
Extended SSID is disabled and up to 16 SSIDs
with Extended SSID enabled.
CLI Configuration
(Instant AP)(config)
# allow-new-aps
(Instant AP)(config)
# terminal-access
(Instant AP)(config)
# console
(Instant AP)(config)
# telnet-server
(Instant AP)(config)
# led-off
(Instant AP)(config)
# extended-ssid
Initial Configuration Tasks | 64