Aruba IAP-335 User Manual page 212

Table 43: Local DHCP Mode Configuration Parameters
Parameter
Name
Type
VLAN
Network
Netmask
Excluded address
Default Router
DNS Server
Domain Name
Lease Time
Option
4. Click OK.
In the CLI
To configure a Local DHCP scope:
(Instant AP)(config)# ip dhcp <profile-name>
(Instant AP)(DHCP Profile <profile-name>)# server-type <local>
(Instant AP)(DHCP Profile <profile-name>)# server-vlan <vlan-ID>
212 | DHCP Configuration
Description
Enter a name for the DHCP scope.
Select any of the following options:
Local—On selecting Local, the DHCP server for local branch network is used for
l
keeping the scope of the subnet local to the IAP. In the NAT mode, the traffic is
forwarded through the IPsec tunnel or the uplink.
Local, L2—On selecting Local, L2, the VC acts as a DHCP server and a default
l
gateway in the local network that is used.
Local, L3—On selecting Local, L3, the VC acts as a DHCP server and a gateway.
l
In this mode, the network address for traffic destined to the corporate network
is translated at the source with the inner IP of the IPsec tunnel and is forwarded
through the IPsec tunnel. The traffic destined to the non-corporate network is
routed.
Specify a VLAN ID. To use this subnet, ensure that the VLAN ID specified here is
assigned to an SSID profile. For more information on SSID profile configuration, see
Configuring VLAN Settings for a WLAN SSID Profile on page 87
VLAN for a Wired Profile on page
Specify the network to use.
If Local; Local, L2; or Local, L3 is selected, specify the subnet mask. The subnet
mask and the network determine the size of the subnet.
Specify a range of IP addresses to exclude. You can add up to two exclusion ranges.
Based on the size of the subnet and the value configured for Excluded address,
the IP addresses either before or after the defined range are excluded.
If Local, L2 is selected for type of DHCP scope, specify the IP address of the default
router.
If required, specify the IP address of a DNS server for the Local; Local, L2; and
Local, L3 scopes.
If required, specify the domain name for the Local; Local, L2; and Local, L3 scopes.
Specify a lease time for the client in minutes within a range of 2–1440 minutes. The
default value is 720 minutes.
Specify the type and a value for the DHCP option. You can configure the
organization-specific DHCP options supported by the DHCP server. For example,
176, 242, and 161. To add multiple DHCP options, click the + icon.
109.
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
and Configuring