Stand-Alone Iap Conversion; Resetting A Remote Ap Or Campus Ap To An Iap; Rebooting The Iap - Aruba IAP-335 User Manual

Figure 108 Stand-Alone IAP Conversion
3. Select Standalone AP from the drop-down list.
4. Select the Access Point from the Access Point to Convert drop-down list.
5. Click Convert Now to complete the conversion. The IAP now operates in the stand-alone mode.
Converting an IAP using CLI
To convert an IAP to a remote AP or campus AP:
(Instant AP)# convert-aos-ap <mode> <controller-IP-address>
To convert an IAP to a stand-alone IAP or to provision an IAP in the cluster mode:
(Instant AP)# swarm-mode <mode>

Resetting a Remote AP or Campus AP to an IAP

The reset knob located on the rear of an IAP can be used to reset the IAP to factory default settings.
To reset an IAP, perform the following steps:
1. Turn off the IAP.
2. Press and hold the reset knob using a small and narrow object such as a paperclip.
3. Turn on the IAP without releasing the reset knob. The power LED flashes within 5 seconds indicating that
the reset is completed.
4. Release the reset knob. The IAP reboots with the factory default settings.

Rebooting the IAP

If you encounter any problem with the IAPs, you can reboot all IAPs or a selected IAP in a network using the
Instant UI. To reboot an IAP:
1. Click Maintenance in the Instant main window.
2. Click the Reboot tab.
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide IAP Maintenance | 358