Table of Contents
Advertisement
Portable RF communications equipment should be used no closer than 30 cm (12 inches) to any part of the access
point. Otherwise, degradation of the performance of this equipment could result.
Access Point Installation
All Aruba access points should be professionally installed by an Aruba-Certified Mobility Professional (ACMP). The
installer is responsible for ensuring that grounding is available and meets applicable national and electrical codes.
Failure to properly install this product may result in physical injury and/or damage to property.
Tous les points d'accès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier doit
s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques
nationaux en vigueur. Le fait de ne pas installer correctement ce produit peut entraîner des blessures corporelles et /
ou des dommages matériels.
For indoor use only. The access point, AC adapter, and all connected cables are not to be installed outdoors. This
stationary device is intended for stationary use in partly temperature controlled weather-protected environments
(class 3.2 per ETSI 300 019).
Software
Aruba 610 Seriesrequires ArubaOS or Aruba Instant8.10.0.0 or later. For instructions on choosing operating
modes and initial software configuration, refer to
Aruba access points are classified as radio transmission devices, and are subject to government regulations of the
host country. The network administrator(s) is/are responsible for ensuring that configuration and operation of this
equipment is in compliance with their country's regulations. For a complete list of approved channels in your country,
refer to the Aruba Downloadable Regulatory Table at https://www.arubanetworks.com/techdocs/DRT/Default.htm.
Verifying Post-Installation Connectivity
The integrated LEDs on the access point can be used to verify that the access point is receiving power and
initializing successfully (see Table 1 and Table 2). Refer to the AP Software Quick Start Guide for further
details on verifying post-installation network connectivity.
Ethernet
E0: 100/1000/2500/5000 Base-T auto-sensing Ethernet RJ-45 Interfaces
l
E1: 100/1000/2500/5000 Base-T auto-sensing Ethernet RJ-45 Interfaces
l
Power
Power over Ethernet (IEEE 802.3at and 802.3bt compliant)
l
12V DC power interface, support powering through AC-to-DC power adapter
l
Maximum power consumption: Refer to datasheet
l
Environmental
Operating
n
Temperature: 0°C to +50°C (+32°F to +122°F)
l
Humidity: 5% to 95% non-condensing
l
Storage
n
Temperature: -40ºC to 70ºC (-40ºF to 158ºF)
l
Rev 01 | July 2022
theAP Software Quick Start
Guide.
|
7
Advertisement
Table of Contents
