Configuring Managed Mode Parameters - Aruba IAP-335 User Manual

Configuring Managed Mode Parameters

To enable the automatic configuration, perform the steps described in the following table:
Table 9: Managed Mode Commands
Steps
1. Start a CLI session to configure the
managed-mode profile for automatic
configuration.
2. Enable automatic configuration
Or
Specify the user credentials.
3. Specify the configuration file.
4. Specify the configuration file
download method.
5. Specify the name of the server or the
IP address of the server from which
the configuration file must be
downloaded.
28 | Automatic Retrieval of Configuration
Command
(Instant AP)(config)# managed-mode-profile
(Instant AP)(managed-mode-profile)# automatic
Or
(Instant AP)(managed-mode-profile)# username <username>
(Instant AP)(managed-mode-profile)# password <password>
NOTE: If the automatic mode is enabled, the user credentials are
automatically generated based on IAP MAC address.
(Instant AP)(managed-mode-profile)# config-filename
<file_name>
Filename—Indicates filename in the alphanumeric format. Ensure that
configuration file name does not exceed 40 characters.
(Instant AP)(managed-mode-profile)# download-method
<ftp|ftps>
You can use either FTP or FTPS for downloading configuration files.
(Instant AP)(managed-mode-profile)# server <server_name>
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide