To Configure The Settings For The Wired Profile; To Configure Vlan Settings For A Wired Profile - Aruba IAP-335 User Manual

5. Enter the following information.
a. Mode—You can specify any of the following modes:
Access—Select this mode to allow the port to carry a single VLAN specified as the native VLAN.
l
Trunk—Select this mode to allow the port to carry packets for multiple VLANs specified as allowed
l
VLANs.
b. Specify any of the following values for Client IP Assignment:
Virtual Controller Assigned: Select this option to allow the VC to assign IP addresses to the wired
l
clients. When the VC assignment is used, the source IP address is translated for all client traffic that
goes through this interface. The VC can also assign a guest VLAN to a wired client.
Network Assigned: Select this option to allow the clients to receive an IP address from the network
l
to which the VC is connected. On selecting this option, the New button to create a VLAN is displayed.
Create a new VLAN if required.
c. If the Trunk mode is selected:
Specify the Allowed VLAN, enter a list of comma separated digits or ranges: for example, 1,2,5 or 1–
l
4, or all. The Allowed VLAN refers to the VLANs carried by the port in Access mode.
If the Client IP Assignment is set to Network Assigned, specify a value for Native VLAN. A VLAN
l
that does not have a VLAN ID tag in the frames is referred to as Native VLAN. You can specify a value
within the range of 1–4093.
d. If the Access mode is selected:
If the Client IP Assignment is set to Virtual Controller Assigned, proceed to step 2.
l
If the Client IP Assignment is set to Network Assigned, specify a value for Access VLAN to
l
indicate the VLAN carried by the port in the Access mode.
6. Click Next to configure
guest users.
In the CLI

To configure the settings for the wired profile:

(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# type <guest>
(Instant AP)(wired ap profile <name>)# speed {10|100|1000|auto}
(Instant AP)(wired ap profile <name>)# duplex {half|full|auto}
(Instant AP)(wired ap profile <name>)# no shutdown
(Instant AP)(wired ap profile <name>)# poe
(Instant AP)(wired ap profile <name>)# uplink-enable
(Instant AP)(wired ap profile <name>)# content-filtering
(Instant AP)(wired ap profile <name>)# spanning-tree

To configure VLAN settings for a wired profile:

(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# switchport-mode {trunk|access}
(Instant AP)(wired ap profile <name>)# allowed-vlan <vlan>
(Instant AP)(wired ap profile <name>)# native-vlan {<guest|1...4095>}
To configure a new VLAN assignment rule:
(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# set-vlan <attribute>{equals|not-equals|starts-
with|ends-with|contains|matches-regular-expression} <operator> <VLAN-ID>|value-of}
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
internal or external captive portal authentication, roles, and access rules
Captive Portal for Guest Access |
for the
125