Authentication Parameters For Management Users - Aruba IAP-335 User Manual

Table 32: Authentication Parameters for Management Users
Type of User
Local administrator
Administrator with
Read-Only Access
Guest
3. Click OK.
146 | Authentication and User Management
Authentication Options
Internal
Authentication server
Internal
Authentication server
Internal
Authentication server
Steps to Follow
Select Internal if you want to specify a single set of user
credentials. If using an internal authentication server:
1. Specify the Username and Password.
2. Retype the password to confirm.
Select the RADIUS or TACACS authentication servers.
You can also create a new server by selecting New
from the Authentication server drop-down list.
Authentication server w/ fallback to internal—
l
Select Authentication server w/ fallback to
internal option if you want to use both internal and
external servers. When enabled, the authentication
switches to Internal if there is no response from the
RADIUS server (RADIUS server timeout). To use this
option, select the authentication servers and
configure the user credentials for internal-server-
based authentication.
Load balancing—If two servers are configured,
l
users can use them in the primary or backup mode,
or load balancing mode. To enable load balancing,
select Enabled from the Load balancing drop-
down list. For more information on load balancing,
see Dynamic Load Balancing between Two
Authentication Servers on page
TACACS accounting—If a TACACS server is
l
selected, enable TACACS accounting to report
management commands if required.
Select Internal to specify a single set of user
credentials.
If using an internal authentication server:
1. Specify the Username and Password.
2. Retype the password to confirm.
If a RADIUS or TACACS server is configured, select
Authentication server for authentication.
Select Internal to specify a single set of user
credentials.
If using an internal authentication server:
1. Specify the Username and Password.
2. Retype the password to confirm.
If a RADIUS or TACACS server is configured, select
Authentication server for authentication.
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
156.