Aruba IAP-335 User Manual page 62

Table 17: System Parameters
Parameter
Timezone
Preferred Band
AppRF Visibility
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Description
Validate certificates.
l
Map an event on one network element to a
l
corresponding event on another.
Maintain accurate time for billing services and
l
similar tasks.
NTP helps obtain the precise time from a server and
regulate the local time in each network element.
Connectivity to a valid NTP server is required to
synchronize the IAP clock to set the correct time. If
NTP server is not configured in the IAP network, an
IAP reboot may lead to variation in time data.
By default, the IAP tries to connect to pool.ntp.org
to synchronize time. The NTP server can also be
provisioned through the DHCP option 42. If the NTP
server is configured, it takes precedence over the
DHCP option 42 provisioned value. The NTP server
provisioned through the DHCP option 42 is used if
no server is configured. The default server
pool.ntp.org is used if no NTP server is configured
or provisioned through DHCP option 42.
NOTE: To facilitate zero-touch provisioning using
the AMP, Central, or Activate, you must configure
the firewall and wired infrastructure to either allow
the NTP traffic to pool.ntp.org, or provide alternative
NTP servers under DHCP options.
Timezone in which the IAP must operate. You can
also enable daylight saving time (DST) on IAPs if the
time zone you selected supports the daylight saving
time. When enabled, the DST ensures that the IAPs
reflect the seasonal time changes in the region they
serve.
The preferred band for the IAP.
NOTE: Reboot the IAP after modifying the radio
profile for changes to take effect.
Select one of the following options from the AppRF
visibility drop-down list.
CLI Configuration
To configure timezone:
(Instant AP)(config)
# clock timezone
<name> <hour-offset>
<minute-offset>
To configure daylight
saving time:
(Instant AP)(config)
# clock summer-time
<timezone> recurring
<start-week> <start-
day> <start-month>
<start-hour> <end-
week> <end-day>
<end-month> <end-
hour>
(Instant AP)(config)
# rf-band <band>
(Instant AP)(config)
# dpi
Initial Configuration Tasks | 62