Table of Contents
Advertisement
This chapter describes the procedures for configuring settings that are specific to an IAP in the cluster.
Modifying the IAP Host Name on page 68
l
Configuring Zone Settings on an IAP on page 68
l
Specifying a Method for Obtaining IP Address on page 69
l
Configuring External Antenna on page 69
l
Configuring Radio Profiles for an IAP on page 70
l
Configuring Uplink VLAN for an IAP on page 72
l
Changing USB Port Status on page 73
l
Master Election and Virtual Controller on page 73
l
Adding an IAP to the Network on page 75
l
Removing an IAP from the Network on page 75
l
Modifying the IAP Host Name
You can change the host name of an IAP through the Instant UI or the CLI.
In the Instant UI
To change the host name:
1. On the Access Points tab, click the IAP you want to rename.
2. Click the edit link.
3. Edit the IAP name in Name. You can specify a name of up to 32 ASCII characters.
4. Click OK.
In the CLI
To change the name:
(Instant AP)# hostname <name>
Configuring Zone Settings on an IAP
All IAPs in a cluster use the same SSID configuration including master and slave IAPs. However, if you want to
assign an SSID to a specific IAP, you can configure zone settings for an IAP.
The following constraints apply to the IAP zone configuration:
An IAP can belong to only one zone and only one zone can be configured on an SSID.
l
If an SSID belongs to a zone, all IAPs in this zone can broadcast this SSID. If no IAP belongs to the zone
l
configured on the SSID, the SSID is not broadcast.
If an SSID does not belong to any zone, all IAPs can broadcast this SSID.
l
You can add anIAP zone by using the UI or the CLI.
For the SSID to be assigned to an IAP, the same zone details must be configured on the SSID. For more
information on SSID configuration, see
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Configuring WLAN Settings for an SSID Profile on page
Chapter 7
Customizing IAP Settings
82.
Customizing IAP Settings |
68
Hide quick links:
Advertisement
Table of Contents
