Aruba IAP-335 User Manual page 63

Table 17: System Parameters
Parameter
URL Visibility
Virtual Controller network
settings
Auto join mode
63 | Initial Configuration Tasks
Description
App—Displays only inbuilt Deep Packet
l
Inspection (DPI) data.
WebCC—Displays the DPI data hosted on the
l
cloud.
All—Displays both App and WebCC DPI data.
l
None—Does not display any AppRF content.
l
Select Enabled or Disabled from the URL visibility
drop-down list.
If the VC IP address is in the same subnet as the IAP,
ensure that you select Custom from the Virtual
Controller network settings drop-down list and
configure the following details:
Virtual Controller Netmask—Enter subnet
l
mask details.
Virtual Controller Gateway—Enter a gateway
l
address.
Virtual Controller DNS—If the DNS IP address
l
is configured for a master IAP, the DNS IP
settings are synchronized for all APs in an IAP
cluster.
If the DNS IP address is configured for an IAP
l
as part of the per IAP setting (Edit Access
Point > General), it takes precedence over
the VC DNS IP address defined in the System
> General window.
If the IAPs are not explicitly assigned a DNS
l
IP address, the DNS IP address defined in
System > General takes precedence.
If the DNS IP address is not defined for IAPs
l
or VC, the DNS address dynamically assigned
from the DHCP server is used.
Virtual Controller VLAN—Ensure that the VLAN
l
defined for the VC is not the same as the native
VLAN of the IAP.
VC VLAN, gateway, and subnet mask details.
The Auto-Join feature allows IAPs to automatically
discover the VC and join the network. The Auto-Join
feature is enabled by default. If the Auto-Join feature
is disabled, a link is displayed in the Access Points
tab indicating that there are new IAPs discovered in
the network. Click this link if you want to add these
IAPs to the network.
CLI Configuration
(Instant AP)(config)
# url-visibility
(Instant AP)(config)
# virtual-
controller-dnsip
<addr>
(Instant AP)(config)
# virtual-
controller-vlan
<vcvlan> <vcmask>
<vcgw>
To disable auto-join
mode:
(Instant AP)(config)
# no allow-new-aps
To enable auto-join
mode:
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide