Table of Contents
Advertisement
f. If required, enable other parameters such as Log, Blacklist, Classify media, Disable scanning, DSCP
tag, and 802.1p priority.
g. Click OK.
5. Click Finish.
In the CLI
To configure destination-NAT access rule:
(Instant AP)(config)# wlan access-rule <access_rule>
(Instant AP)(Access Rule "<access_rule>")# rule <dest> <mask> <match> <protocol> <sport>
<eport> dst-nat ip <IP-address> [<port>]
(Instant AP)(Access Rule "<access_rule>")# end
(Instant AP)# commit apply
Configuring ALG Protocols
You can enable or disable protocols for Application Layer Gateway (ALG) using the Instant UI or the CLI.
In the Instant UI
To enable or disable ALG protocols:
1. Click the Security link located directly above the Search bar on the Instant main window.
2. Click the Firewall Settings tab. The Firewall Settings tab contents are displayed. The following figure
shows the contents of the Firewall Settings tab:
Figure 40 Firewall Settings—ALG Protocols
3. Select Enabled from the corresponding drop-down lists to enable SIP, VOCERA, Alcatel NOE, and Cisco
Skinny protocols.
4. Click OK.
When the protocols for ALG are set to Disabled, the changes are not applied until the existing user sessions
expire. Reboot the IAP and the client, or wait for a few minutes to view the changes.
In the CLI
To configure protocols for ALG:
(Instant AP)(config)# alg
(Instant AP)(ALG)# sccp-disable
(Instant AP)(ALG)# no sip-disable
(Instant AP)(ALG)# no ua-disable
(Instant AP)(ALG)# no vocera-disable
(Instant AP)(ALG)# end
(Instant AP)# commit apply
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Roles and Policies |
188
Hide quick links:
Advertisement
Table of Contents
