Aruba IAP-335 User Manual page 85

Table 21: WLAN Configuration Parameters
Parameter
Content filtering
Inactivity timeout
Deauth Inactive
Clients
SSID
Out of service (OOS)
OOS time (global)
Max clients threshold
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Description
For more information on WMM traffic and DSCP mapping, see
Management on page 276.
For voice traffic and Spectralink Voice Prioritization, configure the following parameters:
Traffic Specification (TSPEC)—To prioritize time-sensitive traffic such as voice traffic
l
initiated by the client, select the Traffic Specification (TSPEC) check box.
TSPEC Bandwidth—To reserve bandwidth, set the TPSEC bandwidth to the desired
l
value within the range of 200–600,000 Kbps. The default value is 2000 Kbps.
Spectralink Voice Protocol (SVP)—Select the check box to prioritize voice traffic for
l
SVP handsets.
Select Enabled to route all DNS requests for the non-corporate domains to OpenDNS on
this network.
Specify an interval for session timeout in seconds, minutes, or hours. If a client session is
inactive for the specified duration, the session expires and the user is required to log in
again. You can specify a value within the range of 60–86,400 seconds (24 hours) for a
client session. The default value is 1000 seconds.
Select Enabled to allow the IAP to send a deauthentication frame to the inactive client and
clear client entry.
Select the Hide check box if you do not want the SSID (network name) to be visible to
users.
Select the Disable check box if you want to disable the SSID. On selecting this, the SSID will
be disabled, but will not be removed from the network. By default, all SSIDs are enabled.
Enable or disable the SSID based on the following OOS states of the IAP:
VPN down
l
Uplink down
l
Internet down
l
Primary uplink down
l
The network will be out of service when selected event occurs and the SSID is enabled or
disabled as per the configuration settings applied. For example, if you select the VPN down
option from the drop-down list and set the status to enabled, the SSID is enabled when the
VPN connection is down and is disabled when the VPN connection is restored.
Configure a hold time interval in seconds within a range of 30–300 seconds, after which
the out-of-service operation is triggered. For example, if the VPN is down and the
configured hold time is 45 seconds, the effect of this out-of-service state impacts the SSID
availability after 45 seconds.
Specify the maximum number of clients that can be configured for each Basic Service Set
Identifier (BSSID) on a WLAN. You can specify a value within the range of 0–255. The
default value is 64.
NOTE: This is a per-ap configuration setting, hence the maximum client threshold is set
Wi-Fi Multimedia Traffic
Wireless Network Profiles | 85