Aruba IAP-335 User Manual page 65

Table 17: System Parameters
Parameter
Deny inter user bridging
Deny local routing
Dynamic CPU Utilization
65 | Initial Configuration Tasks
Description
If you have security and traffic management policies
defined in upstream devices, you can disable
bridging traffic between two clients connected to the
same IAP on the same VLAN. When inter user
bridging is denied, the clients can connect to the
Internet but cannot communicate with each other,
and the bridging traffic between the clients is sent to
the upstream device to make the forwarding
decision.
By default, the Deny inter user bridging
parameter is disabled.
If you have security and traffic management policies
defined in upstream devices, you can disable routing
traffic between two clients connected to the same
IAP on different VLANs. When local routing is
disabled, the clients can connect to the Internet but
cannot communicate with each other, and the
routing traffic between the clients is sent to the
upstream device to make the forwarding decision.
By default, the Deny local routing parameter is
disabled.
IAPs perform various functions such as wired and
wireless client connectivity and traffic flows, wireless
security, network management, and location
tracking. If an IAP is overloaded, it prioritizes the
platform resources across different functions.
Typically, the IAPs manage resources automatically
in real time. However, under special circumstances,
if dynamic resource management needs to be
enforced or disabled altogether, the dynamic CPU
management feature settings can be modified.
To configure dynamic CPU management, select any
of the following options from DYNAMIC CPU
UTILIZATION.
Automatic—When selected, the CPU
l
management is enabled or disabled
automatically during runtime. This decision is
based on real-time load calculations taking into
account all different functions that the CPU
needs to perform. This is the default and
recommended option.
Always Disabled in all APs—When selected,
l
this setting disables CPU management on all
CLI Configuration
(Instant AP)(config)
# deny-inter-user-
bridging
To disable inter-user
bridging for the WLAN
SSID clients:
(Instant AP)(config)
# wlan ssid-profile
<ssid-profile>
(Instant AP)(SSID
Profile <ssid-
profile>)# deny-
inter-user-bridging
(Instant AP)(config)
# deny-local-routing
(Instant AP)(config)
# dynamic-cpu-mgmt
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide