Table of Contents
Advertisement
Figure 3 Installing the Cable Gland
Seals
CAT 5E or Better Cable
Clamping Ring
Sealing Nut
1. Slide the sealing nut over the cable (without the RJ45 connector attached to the end).
2. Slide the clamping ring over the cable.
3. Using a crimping tool, attach the shielded RJ45 connector to the end of the cable.
4. Remove the weatherproof cap on the Ethernet port.
5. Insert the RJ45 connector to the Ethernet port.
6. Screw the clamping ring onto the Ethernet port.
7. Screw the sealing nut onto the clamping ring.
The seals inside the clamping ring by factory default is applicable for cables with 5-8.5 mm diameter. In the
cable gland kit, another seals is provided for use with the cables with 7-10 mm diameter.
Verifying Post-Installation Connectivity
The integrated LED on the AP can be used to verify that the access point is receiving power and
initializing successfully (see
l
and l). Refer to the ArubaOS Quick Start Guide for further details on
verifying post-installation network connectivity.
Configuring the Access Point
The instructions for this section are applicable to the AP-365 and AP-367 only.
Access Point Provisioning/Reprovisioning
Provisioning parameters are unique to each access point. These local access point parameters are
initially configured on the controller which are then pushed out to the AP and stored on the AP itself.
Aruba recommends that provisioning settings be configured via the ArubaOS Web UI only. Refer to
the ArubaOS User Guide for complete details.
Access Point Configuration
Configuration parameters are network or controller specific and are configured and stored on the
controller. Network configuration settings are pushed out to the AP(s) but remain stored on the
controller.
Configuration settings can be configured via the ArubaOS Web UI or ArubaOS CLI. Refer to the
ArubaOS User Guide for complete details.
Aruba 360 Series Outdoor Access Points
| Installation Guide
7
Advertisement
Table of Contents
