Configuring Vlan For A Wired Profile - Aruba IAP-335 User Manual

information on assigning a wired network profile to a port, see
page 113.
c. Spanning Tree—Select the Spanning Tree check box to enable Spanning Tree Protocol (STP) on the
wired profile. STP ensures that there are no loops in any bridged Ethernet network and operates on all
downlink ports, regardless of forwarding mode. STP will not operate on the uplink port and is supported
only on IAPs with three or more ports. By default, Spanning Tree is disabled on wired profiles.
d. Inactivity Timeout—Specify the time out interval within the range of 60–86,400 seconds for inactive
wired clients. The default interval is 1000 seconds.
5. Click Next. The VLAN tab details are displayed.
6. Configure VLAN for the wired profile. For more information, see
page 109.
In the CLI
To configure the settings for a wired profile:
(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# type {<employee>|<guest>}
(Instant AP)(wired ap profile <name>)# speed {10|100|1000|auto}
(Instant AP)(wired ap profile <name>)# duplex {half|full|auto}
(Instant AP)(wired ap profile <name>)# no shutdown
(Instant AP)(wired ap profile <name>)# poe
(Instant AP)(wired ap profile <name>)# uplink-enable
(Instant AP)(wired ap profile <name>)# content-filtering
(Instant AP)(wired ap profile <name>)# spanning-tree
(Instant AP)(wired ap profile <name>)# end
(Instant AP)# commit apply

Configuring VLAN for a Wired Profile

If you are creating a new wired profile, complete the Wired Settings procedure before configuring the VLAN
settings. For more information, see
You can configure VLAN using the Instant UI or the CLI.
In the Instant UI
To configure a VLAN:
1. In the VLAN tab, enter the following information.
a. Mode—You can specify any of the following modes:
Access—Select this mode to allow the port to carry a single VLAN specified as the native VLAN.
l
Trunk—Select this mode to allow the port to carry packets for multiple VLANs specified as allowed
l
VLANs.
b. Specify any of the following values for Client IP Assignment:
Virtual Controller Assigned: Select this option to allow the VC to assign IP addresses to the wired
l
clients. When the VC assignment is used, the source IP address is translated for all client traffic that
goes through this interface. The VC can also assign a guest VLAN to a wired client.
Network Assigned: Select this option to allow the clients to receive an IP address from the network
l
to which the VC is connected. On selecting this option, the New button to create a VLAN is displayed.
Create a new VLAN if required.
c. If the Trunk mode is selected:
Specify the VLAN in Allowed VLAN, enter a list of comma separated digits or ranges, for example,
l
1,2,5 or 1–4, or all. The Allowed VLAN refers to the VLANs carried by the port in Access mode.
109 | Wired Profiles
Configuring Wired Settings on page
Assigning a Profile to Ethernet Ports on
Configuring VLAN for a Wired Profile on
108.
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide