Aruba IAP-335 User Manual page 336

In the Instant UI
To configure Ethernet bridging:
1. On the Access Points tab, click the IAP to modify.
2. Click the edit link.
3. Click the Uplink tab.
4. Select Enable from the Eth0 Bridging drop-down list.
5. Click OK.
6. Reboot the IAP.
In the CLI
To configure Ethernet bridging:
(Instant AP)# enet0-bridging
Make the necessary changes to the wired-profile when eth0 is used as the downlink port. For more
information, see
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Configuring a Wired Profile on page 108.
Mesh IAP Configuration | 336