Uplink Bandwidth Monitoring - Aruba IAP-335 User Manual

VC Uplink Management Configuration
VC WISPr Configuration
VC XML API Server Information
VC rfc3576-radius statistics
Use the support commands under the supervision of Aruba technical support.

Uplink Bandwidth Monitoring

An IAP uses Iperf3 as a TCP or UDP client to run a speed test and measure the bandwidth on an uplink. The
results from the speed test are collated by the IAP and published to Analytics and Location Engine (ALE). The
speed tests can be run only on the master IAP of the cluster. You may choose to configure and execute a speed
test profile during boot time and additionally at specific time intervals using the configuration mode or execute
the speed test at any preferred time using the privileged EXEC mode in the CLI.
To configure and automatically run speed tests at specific time intervals:
(Instant AP)(config)# speed-test
(Instant AP)(speed-test)# include-reverse
(Instant AP)(speed-test)# server-ip <server>
(Instant AP)(speed-test)# server-port <port>
(Instant AP)(speed-test)# protocol <tcp/udp>
(Instant AP)(speed-test)# on-boot
(Instant AP)(speed-test)# time-interval <interval>
(Instant AP)(speed-test)# bandwidth <bandwidth>
(Instant AP)(speed-test)# sec-to-measure <secs>
(Instant AP)(speed-test)# end
(Instant AP)# commit apply
To configure and execute a speed test at any point in time:
(Instant AP)# speed-test <server> <protocol> [<bandwidth>|<include-reverse>|<sec-to-measure>
|<server-port>]
(Instant AP)# end
The view the speed test results:
(Instant AP)# show speed-test data
(Instant AP)# end
Following is an example of the speed-test result
(Instant AP)# show speed-test data
Speed Test results :
Time of Execution :Fri, 11 Nov 2016 07:06:29
Server IP :10.17.138.2
Local IP :10.17.138.92
Local Port :62716
Remote Port :5201
MAC :40:e3:d6:cf:f5:2e
System Name :40:e3:d6:cf:f5:2e
Protocol :TCP
Duration :10
Upstream Bytes :496028352
Upstream Bandwitdh(Mbps) :395.97
upstream retries :0
Downstream Bytes :615227296
Downstream bandwidth (Mbps) :492.18
The following command shows the number of times the uplink bandwidth report was sent to the ALE server.
To display the uplink bandwidth counter:
(Instant AP)# show ale stats
ALE Stats
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
show uplink config
show wispr config
show xml-api-server
show ap debug rfc3576-radius-statistics
Monitoring Devices and Logs | 370