Adding An Iap To The Network; Removing An Iap From The Network - Aruba IAP-335 User Manual

Figure 24 IAP Settings—Provisioning Master IAP
4. Click OK.
In the CLI
To provision an IAP as a master IAP:
(Instant AP)# iap-master
To verify if the IAP is provisioned as master IAP:
(Instant AP)# show ap-env
Antenna Type:Internal
Iap_master:1

Adding an IAP to the Network

To add an IAP to the Instant network, assign an IP address. For more information, see
to the IAP on page
After an IAP is connected to the network, if the Auto-Join feature is enabled, the IAP inherits the configuration
from the VC and is listed in the Access Points tab.
If the auto-join mode is disabled, perform the following steps by using the Instant UI.
In the Instant UI:
To add an IAP to the network:
1. On the Access Points tab, click the New link.
2. In the New Access Point window, enter the MAC address for the new IAP.
3. Click OK.

Removing an IAP from the Network

You can remove an IAP from the network by using the Instant UI, only if the Auto-Join feature is disabled.
75 | Customizing IAP Settings
18.
Assigning an IP address
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide