Table of Contents
Advertisement
Fiber Optic Cable
To use the fiber optic termination kit that is shipped with the AP-85FX/LX models, follow the
instructions in the included Tyco document Instruction Sheet 408-10079.
N O T E
Lightning Arrestor Installation
Refer to the instructions that are shipped with the Aruba lightning arrestor (AP-LAR-1).
Antenna Installation
Refer to the instructions that are shipped with your Aruba outdoor rated antenna.
Verifying Post-Installation Connectivity
The LEDs on the AP-85 can be used after installation to verify that the AP is receiving power, that the
AP is initializing successfully, and that wireless connectivity is occurring (see
page
network connectivity.
Configuring the AP-85
Configuration parameters are network or controller specific and are configured and stored on the
Mobility Controller. Network configuration settings are pushed out to the AP(s) but remain stored on
the Mobility Controller. Configuration settings can be configured via the ArubaOS Web UI, ArubaOS
CLI, or Aruba MMS. Refer to their respective guides for further details: the ArubaOS User Guide or
Aruba Mobility Management System User Guide.
Aruba AP-85 Outdoor Access Point Series
Fiber optic cables are not included and must be purchased separately. Purchase a suitable UV-
resistant, outdoor rated, multi-mode fiber optic cable for use with the AP-85FX and a single-mode
fiber optic cable for use with the AP-85LX.
12). Refer to the ArubaOS Quick Start Guide for further details on verifying post-installation
| Installation Guide
LED Status Indicators on
AP-85 Series Installation |
31
Advertisement
Table of Contents
