Figure 3-9 Fx Series Wccp Definitions Screen - Comtech EF Data FX series 1005 Administrator's Manual

Comtech EF Data / Stampede
WCCP Definitions
This screen allows you to maintain WCCP definitions. A list of previously defined WCCP definitions is
displayed in the order in which
they were defined. An existing
entry may be chosen by clicking
on the router address. By
clicking on "Add" you can add a
new WCCP definition which will
bring up the WCCP definition
screen.
Configure WCCP Definitions
Source IP address:
This is the IP address (must have been already defined as an In-Path interface on the FX) that will be used
when sending WCCP messages to the router. The IP address must be selected from the list of in-path
interfaces.
Router address:
This is the address of the primary router to which WCCP messages will be directed. This setting must be
specified.
Local GRE tunnel address:
This is the IP address of the local end of the GRE tunnel. If this field is not specified then the "Source IP
address" will be used for the local endpoint. This field is not needed if L2 redirection is specified.
FX Series Administration Guide - Version 6.2.2
Chapter: FX Series Configuration
Section: Traffic Interface Settings

Figure 3-9 FX Series WCCP Definitions Screen

73
MN-FXSERIESADM6 Rev 6