Table of Contents
Advertisement
Comtech EF Data / Stampede
2.2
How to Configure Appliance Management Address
2.2.1 All Installation Patterns
Log into the appliance via console or SSH session using the username: comtech and password: comtech
1
Select option 1 "Configure appliance"
2
Select option 1 "Configure network settings"
3
Select option 4 "Configure TCP/IP for eth0 Ethernet Port"
4
Select option 1 "Configure DHCP"
a.
5
Select option 2 "Configure IP Address"
a.
6
Select option 3 "Configure Netmask"
a.
7
Select option 0 "Return to previous menu"
8
Select option 3 "Configure Default Gateway"
a.
Verify network connectivity by doing a ping of the appliance address from an external device.
Depending on the environment, there are several network installation patterns that can be used.
These are each documented in following installation patterns sections.
•
Section 2.3 How to configure FX Series Installation Pattern (In-Line Mode)
•
Section 2.4 How to configure FX Series Installation Pattern (Routed Mode)
•
Section 2.5 How to configure FX Series Installation Pattern (WCCP Mode)
•
Section 2.6 How to Configure Two FX Series Appliances in a Mesh Configuration
FX Series Administration Guide - Version 6.2.2
Chapter: Initial Installation Information
Section: How to Configure Appliance Management Address
Enter no and press Enter key (disable DHCP for this interface)
Enter the IP address of the appliance and press enter
Enter the subnet mask and press the Enter key
Enter the default gateway IP address and press the Enter key
51
MN-FXSERIESADM6 Rev 6
Advertisement
Table of Contents
