How To Shutdown/Restart; Figure 8-5 Fx Series Shutdown/Restart Screen - Comtech EF Data FX series 1005 Administrator's Manual

Comtech EF Data / Stampede

8.1.5 How to Shutdown/Restart

This page allows you to perform software restart operations or to power down or reboot your FX
hardware in an orderly fashion.
Software
Restart Acceleration Service
This button will start the acceleration service if it is
in the "stopped" state or restart it if it is in the
'active' state
Restart Acceleration Service with Full Cache Rest
This button will start the acceleration service if it is
in the "stopped" state or restart it if it is in the
'active' state. Upon doing so, it will reset all the
cache files.
Start or Stop Acceleration Service
This button will either start or stop the
acceleration service depending upon its current
state. When 'stopped', access to the appliance via
the management interfaces is still possible. If the
appliance is configured for "in-band" management
then this button will not be displayed.
Hardware
Shutdown FX Hardware
This button will issue a command to the native operating system to shut down the software in
an orderly fashion and then power down the appliance.
Reboot FX Hardware
This button will issue a command to the native operating system to shut down the software in
an orderly fashion and then reboot the appliance.
FX Series Administration Guide - Version 6.2.2
Chapter: FX Series Operations Features
Section: Basic Operations Functions
Figure 8-5 FX Series Shutdown/Restart
Screen
MN-FXSERIESADM6 Rev 6
151