Comtech EF Data FX series 1005 Administrator's Manual page 53

Comtech EF Data / Stampede
4. Go to Traffic Interfaces-> LAN Interfaces.
a. Click on the "Add" button to add a new LAN
interface.

Select "eth2" in the "Physical interface"
selection box.

In the "In-Path Interface(s)" selection
box, click the IP address of the in-path
interface *from above*.

In the "Untagged in-path interface"
selection box, select the IP address of
the in-path interface *from above*.
Select "None" if the VLAN tag is to be
propagated across the WAN.
b. Click "Add LAN Interface".
Go to Operations -> Shutdown and Restart
Click on the "Restart Service Button"
FX Series Administration Guide - Version 6.2.2
Chapter: Initial Installation Information
Section: How to configure FX Series Installation Pattern (In-Line Mode)
53
MN-FXSERIESADM6 Rev 6