Comtech EF Data FX series 1005 Administrator's Manual page 63

Fx series
Table of Contents

Advertisement

Comtech EF Data / Stampede
Automatically obtain IPv4 address:
If set then the FX appliance will use DHCP to obtain an IP address, subnet mask, and default gateway. The
factory default for the management interface is to use DHCP.
IPv4 Address:
This is the IP address of the management interface.
Subnet Mask:
This specifies the network that the management interface is on. The default value is
255.255.255.0.
Default Gateway:
This is the IP address of the gateway for which packets that are outside the bounds of the
management subnet will be directed. A default gateway address which is on the same subnet as
depicted by the "IPv4 address" and "Subnet mask" must be specified even if the gateway does
not exist.
Speed:
This presents a pull-down selector of speed/duplex combinations that will be set for this interface. The
default value is to automatically negotiate the speed and duplex.
Max Transmit Unit (MTU):
Specifies the max transmit unit. The default value is 1500. The range is 576 to 9000.
Auxiliary Interface
Automatically obtain IPv4 address:
If set, then the FX appliance will use DHCP to get an IP address, subnet mask, default gateway.
IPv4 address:
This is the IP address of the auxiliary interface. The factory default is 169.254.55.55.
Subnet mask:
This specifies the network that the auxiliary interface is on. The default value is 255.255.0.0.
Speed:
This presents a pull-down selector of speed/duplex combinations that will be set for this interface. The
default value is to automatically negotiate the speed and duplex.
Max Transmit Unit (MTU):
Specifies the max transmit unit. The default value is 1500. The range is 576 to 9000.
Management Static Routes
Routes:
Enter into the text area static routes which are used by the management interface. Each static
route must be entered on a separate line and must have exactly the following format:
For example, to define a static route such that subnet 172.88.0.0/16 should be routed by
gateway 172.27.101.99 you would enter the following:
FX Series Administration Guide - Version 6.2.2
Chapter: FX Series Configuration
Section: Management Settings
Subnet "SubnetMask" "Gateway"
172.88.0.0 255.255.0.0 172.27.101.99
63
MN-FXSERIESADM6 Rev 6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fx series 4010Fx series 1010

Table of Contents