Comtech EF Data FX series 1005 Administrator's Manual page 130

Comtech EF Data / Stampede
WAN savings (%):
The "WAN bytes saved" divided by the "WAN bytes processed".
Pass through bytes processed:
This is the total quantity of bytes that have flowed through the acceleration server but no
optimization operations were attempted.
Users:
This is the total quantity of unique IP addresses that have TCP connections flowing through the
FX Remote.
LAN Connections:
This shows the quantity of TCP connections between clients and the FX Remote.
WAN Connections:
This shows the quantity of TCP connections between the FX Remote and FX SERIES ADCs.
Status:
This shows the current state of the acceleration service. Possible values are:






Running since:
This is the date and time when the acceleration server was last started.
Refresh interval (sec):
This is how often WANOP monitor will refresh the statistics. Changes take effect immediately and are
remembered in subsequent accesses to the WANOP monitor.
.
Action Buttons
Detailed stats:
This displays tallies and other stats.
Connections:
This displays the active user connections to the acceleration server.
Reset Stats:
This clears the acceleration server tallies and other stats.
Clear Cache:
This clears all objects out of all caches, and then restarts the acceleration service.
FX Series Administration Guide - Version 6.2.2
Chapter: FX Series Status
Section: FX Series Remote Status
"Active" - The FX is able to perform WAN optimization.
"Invalid Or No License" - The FaST codes for this FX do not exist or do not match this
unit.
"Config-Only Mode" – The FX can be configured, however traffic is not optimized unless
in 'routed' traffic interception mode. If in 'in-line' traffic interception mode, the FX will
go into 'bypass'. If in 'WCCP' traffic interception mode the FX will drop out of all WCCP
service groups. "Config-Only Mode" is set on the 'Configuration->General Settings'
page.
"Overflow – memory" - The FX is low in memory resources. WANOP will continue for
existing accelerated connections, however new connections from clients will be
forwarded directly to the content servers.
"Overflow – sessions" - The FX has reached its specified limit for the number of
concurrent accelerated connections. WANOP will continue for existing accelerated
connections, however new connections from clients will be forwarded directly to the
content servers.
"Overflow - active flows" - The FX has reached its limit of active flows. If in 'in-line'
traffic interception mode, the FX will go into 'bypass'. If in 'WCCP' traffic interception
mode 'the FX will drop out of all WCCP service groups.
130
MN-FXSERIESADM6 Rev 6