Fx-1010 Physical Description; Figure 1-10 Fx Series Fx-1010 Front Panel - Comtech EF Data FX series 1005 Administrator's Manual

Comtech EF Data / Stampede

1.8.9 FX-1010 Physical Description

Front Panel
Power/Status/HDD LED
Power:
If the LED is on it indicates that the system is powered on. If it is off, it indicates that the system is
powered off.
Status:
If the LED is green, it indicates that the system's operational state is normal. If it is red, it indicates
that the system is malfunctioning.
HDD:
If the LED is on, it indicates that the system's storage is functional. If the LED blinks, it indicates
data access activities. If it is off, it indicates that there is no hard disk present or functional.
System Panel: LCD System Panel
The LCD System Panel is programmed to display WOC on the first line and "Active" on the second.
Reset Switch:
The reset switch can be used to reboot the system without turning off the power.
Console Port:
By using suitable rollover cable or RJ-45 to DB-9 Female (Cisco console cable), you can connect to
a computer terminal for diagnostic or configuration purpose. Default terminal Configuration
Parameters: 115200 baud, 8 data bits, no parity, 1 stop bit, no flow control.
Two USB 2.0 Ports:
It connects to any USB devices, for example, a flash drive.
Management Port and Auxiliary Ports:
The Management Port is a Fast Ethernet port that can be connected for configuration or
troubleshooting purpose. It conforms to the IPMI (Intelligent Platform Management Interface)
and can be implemented on this port through the Open Platform Management Architecture
(OPMA) interface.
Eight Gigabit LAN ports (Ports 1-8)
WAN Port - LAN/WAN Port LEDs
Right LED:
If the LED is orange, it indicates that the connection speed is 1000Mbps. If the LED is green, it
indicates that the connection speed is 100Mbps. And if it is off, it indicates that the speed is
10Mbps.
Left LED:
If the LED is on, it indicates that the port is linked. If it blinks, it indicates there is traffic.
Using suitable RJ-45 cable, you can connect FX-1010 system to a computer, or to any other piece
of equipment that has an Ethernet connection; for example, a hub or a switch.
FX Series Administration Guide - Version 6.2.2
Chapter: Overview - FX Series
Section: FX Series Appliances Data Sheet

Figure 1-10 FX Series FX-1010 Front Panel

48
MN-FXSERIESADM6 Rev 6