Comtech EF Data FX series 1005 Administrator's Manual page 58

Comtech EF Data / Stampede
j. If using "web-cache" WCCP redirection, (no source IP address preservation) enter 0 in the
"Service group number" field. If using source IP address preservation use the default value.
k. Use the default values for "Redirect based on", Accept traffic for", and "Ports".
l. If using source IP address preservation select "Enabled" for "Use additional service group". If
using "web-cache" default this value.
m. Click "Add WCCP Definition"
Go to Operations -> Shutdown and Restart
Click on the "Restart Service Button"
NOTE: For more information on "redirection" or configuring on FX1000 appliances or older FX Series 4000
appliances, see the WCCP section: Other WCCP Configurations
FX Series Administration Guide - Version 6.2.2
Chapter: Initial Installation Information
Section: How to configure FX Series Installation Pattern (WCCP Mode)
58
MN-FXSERIESADM6 Rev 6