Fx Series Adc General Settings; Figure 4-1 Fx Series Adc General Edit Screen - Comtech EF Data FX series 1005 Administrator's Manual

Comtech EF Data / Stampede

4 FX Series ADC General Settings

This chapter discusses the General Settings of the FX Series ADC appliances.
FX Series ADC in 'Configuration-Only' Mode:
This setting is useful if you are in the process of configuring your FX Series ADC while the unit is
networked in-line. In "Configuration-Only" mode the in-line networking card is put into "bypass" mode so
that traffic is simply passed through. When you are satisfied that the FX Series ADC is properly configured
you can disable this setting. This setting only applies if the 'Traffic interception mode' is set to "In-Line" or
"WCCP", this setting is ignored if the 'Traffic interception mode' is set to "routed". The default setting is
"Off".
FX Series Administration Guide - Version 6.2.2
Chapter: FX Series ADC General Settings
Section: Redundancy

Figure 4-1 FX Series ADC General Edit Screen

104
MN-FXSERIESADM6 Rev 6