Other - Comtech EF Data FX series 1005 Administrator's Manual

Comtech EF Data / Stampede

4.1.7 Other

Use Spanning-Tree Protocol:
If enabled, then spanning-tree protocol (STP) will be used when operating in "in-line" mode.
Otherwise STP packets will be discarded. The default value is "Enabled".
NOTE: If this setting is changed, it is necessary to restart the acceleration software on the
"Status->Real-time Monitor" screen.
FX Series Administration Guide - Version 6.2.2
Chapter: FX Series ADC General Settings
Section: Redundancy
108
MN-FXSERIESADM6 Rev 6