Festo CPX-FB14 Description page 21

1. Installation
Mounting
Festo P.BE-FB14-EN en 1411d English
Both types of screws are enclosed respectively when the bus
node is ordered as a single part.
Mount the bus node as follows:
1. Check seal and seal surfaces.
2. Place the bus node in the interlinking block. Make sure
that the corresponding grooves with the contacting ter­
minals on the bottom of the bus node are above the con­
tact rails.
3. Then push the bus node carefully and without tilting into
the interlinking block up to the stop.
4. Only tighten the screws by hand. Place the screws so that
the self-cutting threads can be used.
5. Tighten the screws with a TORX screwdriver size T10
with 0.9 ... 1.1 Nm torque.
1-7