Parameterisation - Festo CPX-FB14 Description

2. Commissioning
2.5

Parameterisation

2.5.1 Parameterisation during switch-on
1
Parameterisation
is loaded into the
node by the
master
2
Parameterisation
is distributed to
the modules from
the node
Fig. 2/8: Sequence of start parameterisation
Festo P.BE-FB14-EN en 1411d English
You can set the behaviour of the CPX terminal in the remote
I/O operating mode through individual parameterisation. A
distinction is made between the following parameterisation
types:
– System parameterisation, e.g. switching off of error mes­
sages, etc.
– Parameterisation of the diagnostic memory.
– Module parameterisation (module- and channel-specific),
e.g.: monitoring, settings in case of error, settings of
debounce times of inputs.
Recommendation:
Parameterise the CPX terminal via the SDO in the
pre-operational mode.
A detailed description of the individual parameters as well as
basic principles of application can be found in the CPX system
description (P.BE-CPX-SYS-...).
Parameter lists for CPX I/O modules and CPX pneumatic in­
terfaces can be found in the description for the CPX I/O mod­
ules (P.BE-CPX-EA-...).
Network
1
2
2-91