Adjusting Front Axle Pivot [4Wd]; Every 800 Hours; Adjusting Engine Valve Clearance; Every 1500 Hours - Kubota B26TL Operator's Manual

72 PERIODIC SERVICE OF THE TRACTOR
BAdjusting Front Axle Pivot [4WD]
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, and tighten the adjusting screw so
that the oscillating load is 50 to 100 N (5.1 to 10.2 kgf, 11.2
to 22.5 lbf). (If the adjusting screw is tightened, loosened
and retightened, apply liquid gasket to its tip.) Retighten
the lock nut.
Consult your local KUBOTA Dealer for further details.
(1) Adjusting screw
(2) Lock nut

EVERY 800 HOURS

BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.

EVERY 1500 HOURS

BChecking Fuel Injection Nozzle Injection
Pressure
Consult your local KUBOTA Dealer for this service.

EVERY 3000 HOURS

BChecking Injection Pump
Consult your local KUBOTA Dealer for this service.

EVERY 1 YEAR

BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" section.)

EVERY 2 YEARS

BFlush Cooling System and Changing
Coolant
To avoid personal injury or death:
A Do not remove radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Stop the engine, remove the key and let it cool down.
2. To drain the coolant, open the radiator drain cock, and
remove radiator cap. The radiator cap must be
removed to completely drain the coolant.
3. After all coolant is drained, close the drain cock.
4. Fill with clean soft water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean soft water and anti-freeze
until the coolant level is just below the radiator cap.
Install the radiator cap securely.
7. Fill with coolant up to the "FULL" mark of recovery
tank.
8. Start and operate the engine for few minutes.
9. Stop the engine, remove the key and let cool.
10. Check coolant level of recovery tank and add coolant
if necessary.
11. Properly dispose of used coolant.
Coolant capacity
(1) Radiator cap
(2) Drain cock
4.5 L (4.7 U.S.qts)