Keysight N6705C Operating And Service Manual page 342

7 SCPI Programming Reference
TRIGger:DLOG:CURRent:SLOPe POSitive|NEGative, (@<chanlist>)
TRIGger:DLOG:CURRent:SLOPe? (@<chanlist>)
TRIGger:DLOG:VOLTage:SLOPe POSitive|NEGative, (@<chanlist>)
TRIGger:DLOG:VOLTage:SLOPe? (@<chanlist>)
Sets the slope of the signal. Applies when the data logger trigger source is set to a level.
POSitive specifies a rising slope of the output signal.
NEGative specifies a falling slope of the output signal.
Parameter
POSitive|NEGative, *RST POSitive
Sets the current slope to falling edge: TRIG:DLOG:CURR:SLOP NEG, (@1)
Sets the voltage slope to falling edge: TRIG:DLOG:VOLT:SLOP NEG, (@1)
342
Typical Return
POS or NEG
Keysight N6705C Operating and Service Guide