Keysight N6705C Operating And Service Manual page 362

7 SCPI Programming Reference
A hardware error has occurred on the output.
201 Invalid configuration, empty slots
There is an empty slot between modules. This configuration is not allowed.
202 Selftest Fail
A selftest failure has occurred. See selftest failure list for details.
203 Compatibility function not implemented
The requested compatibility function is not available.
204 NVRAM checksum error
A checksum error has occurred in the instrument's nonvolatile random access memory.
205 NVRAM full
The nonvolatile random access memory of the instrument is full.
206 File not found
The internal calibration file or the internal channel attribute file was not found in NVRAM.
207 Cal file version error
The calibration file was written or read using old firmware. Firmware must be updated.
208 Running backup firmware
The instrument is presently running the backup (previous) version of the firmware.
209 Internal communication error
An internal communication error has occurred in the instrument.
210 Frame NVRAM error
A non-volatile RAM error has occurred in the instrument.
211 Output state couple modules do not match
One or more modules in the group does not match the non-volatile configurations settings.
302 Option not installed
The option that is programmed by this command is not installed.
303 There is not a valid acquisition to fetch from
There is no valid data in the measurement buffer.
304 Volt and curr in incompatible transient modes
Voltage and current cannot be in Step and List mode at the same time.
305 A triggered value is on a different range
362 Keysight N6705C Operating and Service Guide