Keysight N6705C Operating And Service Manual page 36

1 Quick Reference
[:LEVel] <value>{,<value>}, (@chanlist)
:POINts? (@chanlist)
[SOURce:]
POWer
:LIMit?, (@chanlist)
[:SOURce]
RESistance
[:LEVel]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist)
:STATe 0|OFF|1|ON, (@chanlist)
[SOURce:]
STEP
:TOUTput 0|OFF|1|ON, (@chanlist)
[SOURce:]
VOLTage
[:LEVel]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist)
:TRIGgered
[:AMPLitude] <value>, (@chanlist)
:BWIDth LOW|HIGH1|HIGH2|HIGH3, (@chanlist)
:LIMit
[:POSitive]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist)
:COUPle 0|OFF|1|ON, (@chanlist)
:NEGative
[:IMMediate]
[:AMPLitude] <value>, (@chanlist)
:MODE FIXed|STEP|LIST|ARB, (@chanlist)
:PROTection
[:LEVel] <value>, (@chanlist)
:DELay
[:TIME] <value>, (@chanlist)
:REMote
[:POSitive]
[:LEVel] <value>, (@chanlist)
:NEGative
36
Specifies the setting for each list step.
Returns the number of list points (same as steps).
Sets the power limit on output channels.
(RESistance commands only on N6781A, N6785A)
Sets the output resistance level.
Enables/disables output resistance programming.
Specifies whether a trigger out is generated when a transient step occurs.
Sets the output voltage.
Sets the triggered output voltage.
Sets the voltage bandwidth. (only on N678xA SMU)
Sets the positive voltage limit. (only on N678xA SMU)
Sets the voltage limit tracking state. (only on N6784A)
Sets the negative voltage limit. (only on N6784A)
Sets the transient mode.
Sets the over-voltage protection level.
Sets the over-voltage protection delay. (only on N6783A)
Sets the positive remote OV protection level. (only on N678xA SMU)
Keysight N6705C Operating and Service Guide