Keysight N6705C Operating And Service Manual page 35

:SLEW
[:IMMediate] <value>|INFinity, (@chanlist)
:MAXimum 0|OFF|1|ON, (@chanlist)
[SOURce:]
DIGital
:INPut
:DATA?
:OUTPut
:DATA <value>
:PIN<1-7>
:FUNCtion <function>
:POLarity POSitive|NEGative
:TOUTput
:BUS
[:ENABle] 0|OFF|1|ON
[SOURce:]
EMULation <type>, (@chanlist)
[SOURce:]
FUNCtion CURRent|VOLTage, (@chanlist)
[SOURce:]
LIST
:COUNt <value>|INFinity, (@chanlist)
:CURRent
[:LEVel] <value>{,<value>}, (@chanlist)
:POINts? (@chanlist)
:DWELl <value>{,<value>}, (@chanlist)
:POINts? (@chanlist)
:STEP ONCE|AUTO, (@chanlist)
:TERMinate
:LAST 0|OFF|1|ON, (@chanlist)
:TOUTput
:BOSTep
[:DATA] <Bool>{,<Bool>}, (@chanlist)
:POINts? (@chanlist)
:EOSTep
[:DATA] <Bool>{,<Bool>}, (@chanlist)
:POINts? (@chanlist)
:VOLTage
Keysight N6705C Operating and Service Guide
Sets the current slew rate. (only on N678xA SMU)
Enables/disables the maximum slew rate override. (N678xA SMU)
Reads the state of the digital control port.
Sets the state of the digital control port.
Sets the function of the pins.
DIO |DINPut |FAULt |INHibit |ONCouple |OFFCouple |TOUTput |TINPut
Sets the polarity of the pins.
Enables/disables BUS triggers on digital port pins.
Specifies the emulation mode on models N678xA SMU.
PS4Q |PS2Q |PS1Q |BATTery |CHARger |CCLoad |CVLoad |VMETer |AMETer.
Specifies voltage priority or current priority mode. (only on N678xA SMU)
Sets the list repeat count.
Specifies the setting for each list step.
Returns the number of list points (same as steps).
Specifies the dwell time for each list step.
Returns the number of list points (same as steps).
Specifies how the list responds to triggers.
Determines the output value when the list terminates.
Generates a trigger out at the Beginning Of STep
Returns the number of list points (same as steps).
Generates a trigger out at the End Of STep
Returns the number of list points (same as steps).
1 Quick Reference
35