Keysight N6705C Operating And Service Manual page 324

7 SCPI Programming Reference
SENSe:HISTogram:CURRent[:DC]:RANGe[:UPPer] <value>, (@<chanlist>)
SENSe:HISTogram:CURRent[:DC]:RANGe[:UPPer]? [MIN|MAX,] (@<chanlist>)
Selects the current histogram measurement range. The value that you enter must be the highest
value that you expect to measure. Units are in amperes. The instrument selects the range with the
best resolution for the value entered.
Parameter
0 to maximum|MIN|MAX, *RST MAX
Selects the 1 A range: SENS:HIST:CURR:RANG 1, (@1)
When queried, the returned value is the maximum current that can be measured on the range that
l
is presently set.
SENSe:HISTogram:CURRent[:DC]:RANGe:AUTO 0|OFF|1|ON, (@<chanlist>)
SENSe:HISTogram:CURRent[:DC]:RANGe:AUTO? (@<chanlist>)
Enables or disables seamless histogram current measurement autoranging.
Parameter
0|OFF|1|ON, *RST OFF
Enable seamless histogram measurement autoranging:
SENS:HIST:CURR:RANG:AUTO ON, (@1)
Autoranging does not include the 10 μA range, which must be selected individually.
l
SENSe:HISTogram:FUNCtion:CURRent <Bool>, (@<chanlist>)
SENSe:HISTogram:FUNCtion:CURRent? (@<chanlist>)
Enables or disables the current histogram function.
Parameter
0|OFF|1|ON, *RST OFF
Enables current histogram measurements: SENS:HIST:FUNC:CURR ON, (@1)
SENSe:SWEep:OFFSet:POINts <value>, (@<chanlist>)
SENSe:SWEep:OFFSet:POINts? [MIN|MAX,] (@<chanlist>)
Defines the offset in a data sweep for triggered measurements. Positive values represent the delay
after the trigger occurs but before the samples are acquired. Negative values represent data samples
taken prior to the trigger.
324
Typical Return
<maximum value of range>
Typical Return
0 or 1
Typical Return
0 or 1
Keysight N6705C Operating and Service Guide