Delta AH500 Programming Manual page 724

Error code
The checksum of the high-speed data
16#140C
exchange is incorrect. (SM9)
The ID of the actual power supply module is
16#140D not the same as the ID of the power supply
module set in HWCONFIG. (SM9)
The amount of data exchanged at a high
16#140E speed exceeds the maximum amount
supported. (SM10)
16#140F High-speed data exchange error (SM11)
16#1410 Error occurs from RTU I/O module
16#1411 Alarm occurs from RTU I/O module
Cable disconnected from the module Ethernet
16#1420
port
Error occurs when CPU reads data from the
16#1421
Intelligent of Module Configuration.
Error occurs when CPU writes data to the
16#1422
Intelligent of Module Configuration.
There is no interrupt service routine in the
16#1801
CPU module.
There is no END in the program in the PLC.
16#2000
(SM5)
The program is incorrect. There is a syntax
16#2001
error. (SM5)
16#2002 GOEND is used incorrectly. (SM5)
The devices used in the program exceed the
16#2003
range. (SM0/SM5)
The part of the program specified by the label
16#2004 used in CJ/JMP is incorrect, or the label is
used repeatedly. (SM0/SM5)
The N value used in MC is not the same as
the corresponding N value used in MCR, or
16#2005 the number of N values used in MC is not the
same as the number of N values used in
MCR. (SM5)
The N values used in MC do not start from 0,
16#2006 or the N values used in MC are not
continuous. (SM5)
The operands used in ZRST are not used
16#2007
properly. (SM5)
16#200A Invalid instruction (SM5)
The operand n or the other constant operands
16#200B
exceed the range. (SM0/SM5)
16#200C The operands overlap. (SM0/SM5)
An error occurs when the binary number is
16#200D converted into the binary-coded decimal
number. (SM0/SM5)
The string does not end with 0x00.
16#200E
(SM0/SM5)
The instruction does not support the
16#200F
modification by an index register. (SM5)
Description
Ch a pt er 7 Er r or C o des
LED indicator
CPU status
Status
ERROR
Stop Keep
Stop Keep
Stop Keep
Stop Keep
Stop Keep
Continue Keep
Continue Keep
Stop Keep
Stop Keep
Continue Keep
Stop Blinking
Stop Blinking
Stop Blinking
Self-defined Blinking
Stop Blinking
Stop Blinking
Stop Blinking
Stop Blinking
Stop Blinking
Self-defined
Blinking
Self-defined Blinking
Self-defined
Blinking
Self-defined
Blinking
Stop Blinking
BUS
FAULT
ON
ON
ON
ON
ON
ON
Keep
ON
ON
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
Keep
7 - 5