Delta AH500 Programming Manual page 306

AH 5 00 Pr ogr am m ing Ma n ua l
Example 3:
The states of the devices are listed below.
State of the
Device contact before the
execution of CJ
M1, M2, and M3
are OFF.
Y, M, and S
M1, M2, and M3
are ON.
M4 is OFF.
Timer
M4 is ON.
M6 is OFF.
Accumulative
timer
M6 is ON.
M7 and M10 are
OFF.
Counter
M7 is OFF. M10 is
ON/OFF.
M11 is OFF.
Applied
instruction
M11 is ON.
*1:Y0.1 is a dual output. When M0 is OFF, Y0.1 is controlled by M1. When M0 is ON, Y0.1 is
controlled by M12.
6 - 1 3 8
State of the contact during
the execution of CJ
M1, M2, and M3 are
switched from OFF to ON.
M1, M2, and M3 are
switched from ON to OFF.
M4 is switched from OFF
to ON.
M4 is switched from ON to
OFF
M6 is switched from OFF
to ON.
M6 is switched from ON to
OFF.
M10 is ON/OFF.
M10 is ON/OFF.
M11 is switched from OFF
to ON
M11 is switched from ON
to OFF
State of the output coil during
the execution of CJ
*1
Y0.1 , M20, and S1 are OFF.
*1
Y0.1 , M20, and S1 are ON.
The timer is not enabled.
The timer stops counting
immediately. When M0 is
switched from ON to OFF, the
timer is reset to 0.
ST1 is not enabled.
If the instruction CJ is
executed after the
accumulative timer is enabled,
the accumulative timer stops
counting.
The counter is not enabled.
C0 stops counting. When M0 is
switched OFF, C0 keeps
counting.
The applied instruction is not
executed.
The applied instruction which
is skipped is not executed.